Kayak Stand

[Jay H]

I stole this idea about the folks at Placid Boatwerks in Lake Placid...



6-2x4 x 8'
a pack of 25 #12 2.5" wood screws
some nylon rope I had lying around
2 pool noodles I used to use..

the required tools to cut 2x4s and screw in the screws.. and a measuring tape, pencil and t-square..

Jay

 

[sardog1]

I just knew there was a reason I left the circular saw lying around. Thanks for posting!

 

[Jay H]

You're welcome... Even at Home Despot with "premium lumber" I think it cost me less than $30 to make and I used about 5 1/3 of my 2x4s...

I'm going to see if I can fit my Pungo on the bottom for when Pungo season comes and goes...

Jay

 

[gaiagirl]

Nice work! I used two old sawhorses and added some flexible plastic sheeting in a U shape with some screws so that I can get my boat to sit within, upside down. It works nicely for me.